Need help?Do you have a question about the Fender Rumble 800 and is the answer not in the manual?
General| Power | 800 Watts |
|---|---|
| Horn | Yes |
| Inputs | 1 x 1/4", 1 x XLR |
| Outputs | 1 x XLR, 1 x 1/4" |
| Controls | Gain, Bass, Treble, Master |
| Type | Bass Combo Amplifier |
| Channels | 1 |
| Effects Loop | Yes |
| Footswitch | Yes (optional) |
| Speaker Configuration | 2 x 10" speakers |
Connects passive or active bass. Adjust GAIN to prevent distortion.
Optimizes preamp signal level for basses, affects distortion/compression.
Tone shaping options: BRIGHT for presence, CONTOUR for mid-cut, VINTAGE for dark tone.
Controls the amount of preamp distortion when OVERDRIVE is engaged.
Engages the OVERDRIVE circuit. Light indicates activation.
Adjusts OVERDRIVE volume to balance with clean tone.
Adjusts overall tone and compensates for room acoustics using four bands.
Controls overall amp volume and engages Delta-Comp limiter at higher settings.
Indicates amp status: power on, output limit, or protect mode.
Explains how the amplifier manages heat, including fan operation and protection modes.
Lists specific Fender part numbers for the Rumble 800 Head across various global regions.
Presents a table detailing the presence and levels of hazardous substances in amplifier components.
To Next Page
