Fender SUPER CHAMP X2 COMBO - User Manual

SUPER CHAMP X2 COMBO/ HEAD™
(This is the model name for warranty claims)
Fender Musical Instruments Corporation, 17600 North Perimeter Drive, Suite 100 Scottsdale, AZ 85255
Issued: March 2012
COMBO p/n 2223000000 (120V)
HEAD p/n 2223100000 (120V)
SERVICE MANUAL
ATTENTION:
WARRANTY SERVICE PROCEDURES
The Super Champ X2 Combo and Head are considered to be field serviceable to the
component level. Except for the µDSP PCB which must be replaced as a complete
module. We do however understand that some circumstances may require replacement of
other PCB Assemblies. Any Fender Authorized Service Center in need of a warranty
replacement PCB Assembly for this unit should contact FMIC Tech Support by phone at
(866) 345-3642 or email: sevice@fender.com

Fender SUPER CHAMP X2 COMBO Specifications

General

Type	Tube Amplifier
Number of Channels	2
Total Power	15 Watts
Speaker Size	10 inches
Reverb	Yes
Amp Modeling	Yes
USB	Yes
Power Tubes	2 x 6V6
Height	16.5 inches
Depth	9.5 inches
Weight	24 lbs
Inputs	1 x 1/4"
Footswitch I/O	1 x 1/4"

Summary

Warranty Service Procedures

Parts List Codes

Specifications

Service Notes

Chassis Removal

Procedure for removing the chassis from the amplifier cabinet.

Main PCB Removal

Steps for removing the main printed circuit board assembly.

PCB Exchange Policy

Circuit Description

Main PCB Circuitry

Description of the main PCB's circuitry functions and controls.

Pre-Amplifier Circuitry

Explanation of the pre-amplifier stage's design and signal path.

µDSP PCB Description

Description of the µDSP PCB, its functions, and serviceability.

USB PCB Description

Description of the USB interface PCB and its purpose.

Power Supply Circuitry

Explanation of the power supply section's design and voltage generation.

Main PCB Parts List

USB PCB Parts List

Chassis Assembly Parts List

End Item Assembly Parts List

Combo Cabinet Assembly Parts List

Head Cabinet Assembly Parts List

Service Diagram List