wwwwww
..
ffeennddeerr..ccoomm
✧
wwwwww
..mmrrggeeaarrhheeaadd..nneett
Front Panel Features:
• Fender
®
passive tone stack (remember passive
means CUT ONLY)
•• Delivers that creamy tube tone
•• Volume, Bass, Mid & Treble controls for the
“clean” sound
•• Pull Deep and Bright boost switches
•• A (roughly) flat tone would be with the EQ set
Bass: 2, Mid: 10, Treble: 2, with no Deep or
Bright boosts active
• Tube Overdrive section
•• Gain, Volume and Blend
•• This channel sits on top of the clean (which
preserves the warm clean pillow under the
overdrive)
•• Blend adjusts the clean vs. dirty ratio of the
tone (can be set “touch-sensitive”)
•• Footswitchable (4-button footswitch is
included)
• Vari-Q™ section – A smart semi-parametric EQ
•• Cutting frequencies automatically DECREASES
the width of the Q for a narrow, defined cut
(notch)
•• Boosting frequencies automatically INCREASES
the width of the Q for a broader, more musical
boost
•• This intelligent Q control keeps “on the fly”
operation simple and effective
•• Footswitchable (4-button footswitch is
included)
• Room Balance – Global EQ shift for cabinet/stage
response
•• Clockwise cuts lower frequencies while
simultaneously boosting upper frequencies
•• Counter-clockwise boosts lower frequencies
while simultaneously cutting upper frequencies
•• Room Balance Does NOT affect BALANCED
LINE OUT output (soundman gets unaltered
signal)
• Master Volume – One level control that affects
everything (except Balanced Line Out, Tuner and
FX Send)
• Mute
•• Cuts all signal except for the Tuner and FX
Send
•• Footswitchable (4-button footswitch is
included)
Rear Panel Features:
• BALANCED LINE OUTPUT with Ground Lift and
Pre/Post switches and Level control
• Jensen
®
Line Out Transformer (THE output
transformer for maintaining a clean Balanced Line
Out signal)
• Tuner Send (always on, even when the MUTE is
engaged)
• Effects Loop with Trim control and level shift
switch (can also be used as an adjustable boost
control)
•• Footswitchable (4-button footswitch is
included)
• Bi-amp low and high sends with active crossover
(as big as you need it to be)
• Full-Range Main Output
• Footswitch input (4-button controls: Overdrive, FX
Loop, Vari-Q™ and Mute)
• Additional Instrument Input on the back (in case
your rack setup prefers having the input
connection in the back)
Feature Set
7
TT
TT
BB
BB
PP
PP
--
--
11
11
To Next Page
Loading...
Need help?
General