What to do if my Ferguson ARIVA T30 says 'No Signal'?
If your Ferguson TV Receiver shows a 'No Signal' message, first ensure the DVB-T2 cable is securely connected. If the issue persists, try resetting the device settings.
Why is my Ferguson ARIVA T30 TV Receiver showing only sound, but no image?
If you're getting only sound and no image on your Ferguson TV Receiver, check the AV cable connections to ensure they are properly connected. If the connections are correct, make sure that the program you are trying to watch is not a radio program. If it is, press the TV/RADIO button to switch to TV mode.
Why is the remote not responding to my Ferguson ARIVA T30?
If your Ferguson TV Receiver's remote isn't responding, the first thing to check is the batteries. Replace them if they're exhausted. If new batteries don't solve the problem, make sure you're pointing the remote directly at the receiver and that you are close enough to the device.
How to fix a Ferguson TV Receiver with no picture?
If your Ferguson TV Receiver shows no picture, ensure the power is connected properly. If it is, verify that the receiver is turned on.
Why is there no sound from my Ferguson ARIVA T30 TV Receiver speaker?
If there's no sound coming from your Ferguson TV Receiver's speaker, first check the audio cable connections to ensure they are correctly connected. Also, verify that the MUTE function is turned off. If the problem persists, try selecting a different soundtrack, as the current one might be incorrect.
What to do if Ferguson ARIVA T30 image freezes or shows mosaic?
If the image on your Ferguson TV Receiver is freezing or showing a mosaic effect, it's likely due to a weak signal. You should try to strengthen the signal.
General| Tuner Type | DVB-T/T2 |
|---|---|
| Video Output | HDMI, SCART |
| Supported Resolutions | 576i, 576p, 720p, 1080i, 1080p |
| Card Reader | No |
| EPG | Yes |
| Teletext | Yes |
| Subtitles | Yes |
| Storage Capacity | USB external drive |
| Connectivity | USB 2.0 |
| Video Decoding | MPEG-2, MPEG-4, H.264 |
| Audio Decoding | MPEG-1 Layer I/II, AAC |
Connects USB memory devices for data input.
Connects to an external antenna.
Provides high-definition audio and video output.
Connects the receiver to your TV.
Covers power, mute, volume, menu, exit, and channel navigation.
Guide to setting OSD language, country, and initiating channel search.
Performing automatic or manual channel searches.
Resolving issues with no picture or 'No Signal' messages.
Troubleshooting no sound or incorrect audio track.
To Next Page
