Ferm ATM1043 - Page 6

6
EN
5. MAINTENANCE
Maintenance
Themachinedoesnotrequireanyspecial
maintenance. Regulary check the tool for possible
damages
Lubrication
Fig. G
Pneumatictoolsshouldbelubricatedfrequently.
• Mountanin-lineoilerbetweenthetoolandthe
air hose.
• Ifnoin-lineoilerisinstalled,insertafewdrops
of oil into the air hose connection before use.
Lubricating the impact mechanism
Fig. G
The impact mechanism must be lubricated on a
daily basis.
• Removethescrew(12)fromtheoilfillingpoint
(13).
• Insertafewdropsofoilintothemechanism.
• Replacethescrewandtightenit.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
ENVIRONMENT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
GUARANTEE
The guarantee conditions can be found on the
separately enclosed guarantee card.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.