Ferm OTM1005 - Carbon Brush Maintenance; Warranty Information; Environmental Considerations; Product Disposal

8
EN
Checking and replacing the carbon brushes
Fig. A + D
The carbon brushes must be checked regularly.
Ifthecarbonbrushesareworn,themachinewill
start to run unevenly.
Only use the correct type of carbon
brushes.
• Removethecarbonbrushholders(13)usinga
screwdriver.
• Cleanthecarbonbrushes.
• Incaseofwear,replacebothcarbonbrushes
at the same time.
• Mountthecarbonbrushholders(13)usinga
screwdriver.
• Aftermountingthenewcarbonbrushes,letthe
machine run at no load for 15 minutes.
WARRANTY
Consulttheenclosedwarrantyterms.
ENVIRONMENT
Disposal
The product, the accessories, and the
packaging must be sorted for
environmentally friendly recycling.
Only for EC countries
Donotdisposeofpowertoolsintodomestic
waste.AccordingtotheEuropeanGuideline
2012/19/EUforWasteElectricalandElectronic
Equipmentanditsimplementationintonational
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally friendly way.
The product and the user manual are subject to
change. Specifications can be changed without
further notice.