Ferm OTM1005 - Using the Multitool; Powering On;Off; Speed Adjustment; Tips for Optimal Use

7
EN
Removing
• Placethemachineonatablewiththemounting
point(3)facingupwards.
• LoosentheAllenscrew(7)usingtheAllenkey(5).
• Removethespacer(8).
• Removethesawblade(11)fromthemounting
point(3).
• Mountthespacer(8).
• TightentheAllenscrew(7)usingtheAllenkey(5).
Mounting and removing the scraping knife (fig. B)
The scraping knife must be used for scraping
applications.
Mounting
• Placethemachineonatablewiththemounting
point(3)facingupwards.
• LoosentheAllenscrew(7)usingtheAllenkey(5).
• Removethespacer(8).
• Mountthescrapingknife(12)tothemounting
point(3).
• Mountthespacer(8).
• TightentheAllenscrew(7)usingtheAllenkey(5).
Removing
• Placethemachineonatablewiththemounting
point(3)facingupwards.
• LoosentheAllenscrew(7)usingtheAllenkey(5).
• Removethespacer(8).
• Removethescrapingknife(12)fromthemounting
point(3).
• Mountthespacer(8).
• TightentheAllenscrew(7)usingtheAllenkey(5).
USE
Switching on and off (fig. A)
• Toswitchonthemachine,slidetheon/off
switch(1)tothefront.
• Toswitchoffthemachine,slidetheon/off
switch(1)totherear.
Setting the speed (fig. A)
The speed adjustment wheel is used for setting
the speed. The speed adjustment wheel can be
setto6positions.
The ideal speed depends on the application and
on the material to be worked.
Do not set the speed during use.
• Turnthespeedadjustmentwheel(2)tothe
requiredposition.
Hints for optimum use
• Clamptheworkpiece.Useaclampingdevice
for small workpieces.
• Drawalinetodefinethedirectioninwhichto
guide the accessory.
• Firmlyholdthemachinebythegrip.
• Switchonthemachine.
• Waituntilthemachinehasreachedfullspeed.
• Placetheaccessoryontheworkpiece.
• Slowlymovethemachinealongthepre-drawn
line, firmly pressing the accessory against the
workpiece.
• Donotapplytoomuchpressureonthemachine.
Letthemachinedothework.
• Switchoffthemachineandwaitforthemachine
to come to a complete standstill before putting
the machine down.
CLEANING AND MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
• Regularlycleanthehousingwithasoftcloth.
• Keeptheventilationslotsfreefromdustand
dirt.Ifnecessary,useasoft,moistclothto
remove dust and dirt from the ventilation slots.
Replacing the accessories (fig. B)
Worn or damaged accessories must be replaced
immediately.
Only use sharp and undamaged
accessories.
• Toremovetheaccessory,proceedasdescribed
in the corresponding section.
• Tomounttheaccessory,proceedasdescribed
in the corresponding section.