Ferno 125 - Using the KED; Applying the Cervical Collar; Removing the KED from the Carrying Case

16
© Ferno-Washington, Inc. 234-1754-02 April 2001
Using the KED Model 125 KED
5.3 Applying the Cervical Collar
Apply the cervical collar according to local protocols
and the manufacturer’s instructions.
Maintain manual stabilization of the patient’s head and
neck until the patient is properly secured on a long spine
board.
In Figure 17, one operator holds the patient’s head and
neck in neutral alignment while the other operator
applies Ferno’s WizLoc cervical collar.
5.4 Removing the KED from the
Carrying Case
The KED carrying case is designed for quick removal
of the KED, as follows:
1. Stand the carrying case containing the KED on
end with the open end of the case facing upward.
Where the case meets the ground, there will be a
left and right “dog ear” (Figure 18).
2. Place your foot on one of the “dog ears” to hold
the case in place while you pull the KED out of
the case (Figure 18)
3. Unroll the KED and lay the Adjusta-Pad and head
straps aside.
Figure 18 - Removing the KED From Its
Carrying Case
Figure 17 - Applying the WizLoc®
Cervical Collar
“Dog Ear”