Ferno KED Pro - Storing Leg Straps

30
© Ferno-Washington, Inc 234-3396-00 January 2011
KED® Pro
Storing the KED® Pro
LEG STRAPS
Storing the leg straps as described here will keep them out
of the way while sliding the KED
®
Pro between the patient
and the vehicle seat, yet readily available when you want
to use them. Leave the leg straps in their stored position in
situations where you choose not to use them.
The leg pads may be stored on the leg straps, as shown here,
or in the accessories pouch of the carrying case.
Figure 61 - Wrapping the Leg Straps
Store the leg straps as follows:
1. Lengthen the leg strap until about six inches of
webbing have not passed backward through the buckle
slide.
2. Beginning at the point where the strap is attached to
the KED
®
Pro, wrap the strap down around the bottom
edge of the KED
®
Pro then up and around the inside of
the KED
®
Pro (Figure 61).
3. Turnthebuckleundertorestushagainstthewebbing
and secure the strap in place by pressing its hook-and-
loop fastening strip against a fastening strip on the
outside of the KED
®
Pro (Figure 62).
Figure 62 - Press the Strap Hook-and-Loop
Material Against the Mating Material on
the Outside of the KED® Pro