A32 inputs and outputs
20
A32 inputs and outputs – analog: D-Sub25
All analog inputs and outputs are fully balanced and can send or
receive levels of +4dBu, +13dBu or +20dBu. Each channel can be set
independently. You can also set levels between these three reference
levels, which will be achieved digitally using the DSP. If setting the
input and output levels exactly to one of the three reference levels,
there is no digital gain calculation by the DSP.
D-Sub25 connectors are used for the analog inputs and outputs. The
pin configuration corresponds to the TASCAM® standard.
When connecting an unbalanced device to the A32’s input, please
connect the inverting (cold) input channel to ground.
When connecting an unbalanced device to the A32’s output, please
leave the inverting (cold) output channel open (not connected).
Please note that unlike analog systems, digital systems
do not have any soft clipping zone. When converting
analog signals, leave sufficient headroom to avoid
digital distortion.
To Next Page
Loading...
