12
AP-KA 65
GB
10.2 Processing shaped parts
The following measures make processing of
shaped parts easier:
Use an additional roller as a second contact
point for extra stability.
Secure guide plates to the underside of the
workpiece, e.g. using double-sided adhesive
tape because the workpiece could become
stuck if the guide plates are fixed.
On small workpieces, a piece of wood 6 mm
thick can be secured to the underside of the
workpiece instead of the guide plates.
10.3 Attaching solid wood edging
Brittle solid wood edging breaks easily. The follow-
ing preventive measures can be taken:
Use an additional roller to increase the bending
radius of the edge band.
Guide the workpiece at an angle of approx. 5° -
10° in relation to the contact roller
[12]
.
11 Accessories
Always use accessories and consumable materials
approved by Festool. See Festool catalogue or
www.festool.com.
Customer service and repair
only
through manufacturer or service
workshops: Please find the nearest
address at: www.festool.com/service
Use only original Festool spare parts!
Order No. at: www.festool.com/service
12 Environment
Do not dispose of the device together with domes-
tic waste!
Dispose of machines, accessories and
packaging at an environmentally responsible recy-
cling centre. Observe the valid national regulations.
Information on REACh:
www.festool.com/reach
EKAT
1
2
3
5
4