www.festoolusa.com
If for some reason your cut is not perfect, first troubleshoot the situation. Is the guide rail
sitting flat on the workpiece? Is the workpiece warped? Did the guide rail slide during the
cut? If the problem is the angle of the saw, you can adjust it. First loosen the two rotary
knobs and the saw will tilt up to 45 degrees. Near each knob you will find a hex head bolt.
These are stops when the blade is set at 90 degrees to the workpiece. You can fine tune the
angle of the saw by adjusting them up or down. Chances are good that you won’t ever have
to do this. I’ve set up and used maybe a dozen saws over the years and every one has been
spot-on right out of the box. But once when I dropped my saw, I found these adjustment
bolts very useful.
6
To Previous Page
Loading...
