Festool ATF 55 User Manual

www.festoolusa.com
Tips on Setting Up an ATF 55 or AT 65 circular saw
The amazing Festool pendulum saw will live up to its reputation right out of the box—that it
will ride on a guide rail that sticks magically to the workpiece, that it can crosscut plywood
without chipping, that it can give a cabinetsaw grade cut, and so on and so forth. It will do
all this, however, if it is first set up properly. There’s not much to do, but it’s essential to get
the most out of your saw.
So what should you do when you first get your saw? Read the manual, of course! (Hey—
there’s important information there). This photo essay complements the manual, offering
more detail of some aspects of set up and tuning, as well as a few tips not found in the
manual.
1

Festool ATF 55 Specifications

General

Power consumption	1200 W
Saw blade diameter	160 mm
Cutting depth 0°	55 mm
Cutting depth at 90°	55 mm
Dust extraction connection diameter	27 mm

Summary

Introduction to Festool Saw Setup

Initial Saw and Guide Rail Adjustment

Adjusting Guide Jaws

Eliminate side-to-side play by tightening guide jaws for smooth saw movement on the rail.

Optimizing Cut Quality

Lubrication and Splinterguard Trimming

Apply dry lubricant and trim the guide rail's splinterguard for precise, chip-free cuts.

Making the First Cut

Perform an initial cut to establish the correct blade depth and speed for optimal results.

Verifying Cut Accuracy

Check cut squareness and test on splintery material for a perfect, splinter-free edge.

Troubleshooting and Fine-Tuning Saw Angle

Adjusting Saw Angle for Precision

Fine-tune the saw's angle using adjustment bolts to ensure precise 90-degree cuts and troubleshoot issues.