11
Extracting dry materials
Remember:
A damp main filter will clog more
quickly when dry materials are extracted. There-
fore, dry the main filter before extracting dust or re-
place the damp filter with a dry one.
Extracting fluids
L
The main filter shall only be used for extracting
dry materials.
Before extracting fluids, remove the filter bag (see
chapter "Changing the filter bag"). We recom-
mend using a special wet filter.
The dust extractor stops automatically when the
maximum level is reached.
Filter
Changing the filter bag
Inserting the filter bag
X
Open the locking clips
[2-2]
and remove the top
section of the machine
[2-1]
.
X
Insert a new filter bag (FIS-CT 26/36) (Fig.
[5]
)
in the inlet port of the dust container and inter-
lock it.
Important:
be aware that the locking en-
gages.
L
Make sure that the filter bag is not pinched be-
tween the top and bottom sections.
X
Replace the top section
[2-1]
and close the
locking clips
[2-2]
.
Removing the filter bag
X
Open the locking clips
[2-2]
and remove the top
section of the machine
[2-1]
.
X
Remove the filter bag (Fig.
[6]
).
X
Dispose of the used bag in accordance with stat-
utory regulations.
X
Clean the dust container
[2-3]
.
WARNING
Not suitable to vacuum hazardous or toxic sub-
stances or dusts e.g. asbestos.
X
The filters will not be able to capture all particles
and may exhaust them back into the environment.
WARNING
Risk of injury
X
Do not evacuate combustible liquids!
CAUTION
Escaping foam and fluids
X
Switch off the machine immediately and empty
the dust container.
WARNING
Risk of injury
X
During the following procedure, take care not to
raise dust more than is unavoidable. Moisten the
main filter with a water spray before removing it.
To Next Page
Loading...
