Customer service and repairs must
only be carried out by the manufac
turer or service workshops. Find the
nearest address at:
www.festoolusa.com/service
Always use original Festool spare
parts. Order no. at:
www.festoolusa.com/service
► Regularly clean the fill level sensors [9] and
empty the dirt trap
[1-9].
Observe the following information:
– Dust-related inspection (e.g. for filter dam
age, tightness of the machine and function
of the control devices) by the manufacturer
or an instructed person at least once a
year.
– Dispose of components that cannot be
cleaned. Use impermeable bags to do so.
Observe the applicable disposal provisions!
– Keep the contacts on the cordless mobile
dust extractor, charger and battery pack
clean.
Refer to the Festool catalogue for the order
numbers of accessories and tools or find them
online at www.festoolusa.com.
16 Transportation
Observe the following information:
– Always lock the T-Loc lock on the cordless
mobile dust extractor prior to transporta
tion.
– Only carry it by the handle [1-1].
– For transportation in vehicles, secure the
cordless mobile dust extractor against slip
ping and tilting in accordance with the valid
guidelines.
17 Environment
Do not dispose of the device together with do
mestic waste! Dispose of machines, accesso
ries and packaging at an environmentally re
sponsible recycling centre. Observe the valid
national regulations.
Battery Disposal
WARNING
Risk of fire or injury
► Do not attempt to disassemble the battery
or remove any component projecting from
the battery terminals.
► Prior to disposal, protect exposed termi
nals with heavy insulating tape to prevent
shorting.
18 General information
18.1
Information about Bluetooth
®
As soon as the tool is connected to the Festool
Work app via Bluetooth
®
and the secure con
nection has been authorised, the tool will con
nect automatically to the Festool Work app
from this point onwards. The tool then regularly
sends status information (ID, operating status,
etc.) via Bluetooth
®
.
The Bluetooth
®
word mark and the logos are
registered trademarks of Bluetooth SIG, Inc.;
they are used by TTS Tooltechnic Systems AG &
Co. KG, and therefore by Festool, under licence.
18.2 Information on data privacy
The tool contains a chip which automatically
stores machine and operating data. The data
saved cannot be traced back directly to an indi
vidual.
The data can be read in a contactless manner
using special devices and shall only be used by
Festool for fault diagnosis, repair and warranty
processing and for quality improvement or en
hancement of the device. The data shall not be
used in any other way without the express con
sent of the customer.
18.3 USA: Federal Communications
Commission (FCC) Interference
Statement
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interfer
ence in a residential installation. This equip
ment generates, uses and can radiate radio fre
English
19
To Next Page
Loading...
Need help?
General
