7
1 Safety instructions
Before using the machine, read the
enclosed safety instructions and the-
se operating instructions carefully
and thoroughly.
Save all enclosed documents and pass the
machine with all these documents only.
Always wear protective goggles
because of possible dangers when
sanding.
The manufacturer’s handling and proces-
sing instructions must be observed without
fail if explosive or self-igniting dusts are
likely to occur during sanding.
Harmful/toxic dusts can occur during your
work (e.g. lead-containing paint, some
types of wood and metal). Contact with
these dusts, especially inhaling them, can
represent a hazard for operating person-
nel or persons in the vicinity. Comply with
the safety regulations that apply in your
country. Connect the electric power tool to
a suitable extraction system.
To protect your health, wear a P2
protective mask.
2 Correct usage
The sanders are designed for sanding wood,
plastic, composite materials, paint / var-
nish, fi lling material and similar materials.
Metal and materials with an asbestos con-
tent must not be processed with these
tools.
The machines must not be damp nor ope-
rated in a damp environment for electrical
safety reasons. The machines may only be
used for dry sanding. The user bears sole
responsibility for any damage or accidents
resulting from incorrect use.
3 Noise and vibration informati-
on
Typical values established in compliance
with EN 60745:
Sound pressure level 72 dB(A)
Sound-power level 83 dB(A)
Measuring uncertainty allowance K = 4 dB
Measured acceleration 6.0 m/s²
4 Electrical connection and opera-
tion
The mains voltage must corre-
spond with the voltage on the
rating plate!
Switch (1.2) is an on/off switch. For con-
tinuous use it can be engaged with the
lateral locking button (1.3). Pressing the
switch again releases the lock. See Fig.
3 for connection and disconnection of the
power cable.
5 Electronic control
The ETS 150/3 EQ, ETS 150/5 EQ
has an electronic control with which
the rotational speed can be varied
step-free.
This allows the sanding speed to be adap-
ted to the optimum level according to the
material concerned (see Chapter 9). The
speed is set using the rotary control button
(1.1).
6 Dust extraction
Dust extractors prevent large accu-
mulations of dust in the air in the
working environment and dirt coll-
ecting in the workplace.
Technical data ETS 150/3 EQ ETS 150/5 EQ
Wattage 310 W 310 W
Speed (220 - 240 V) 4,000 - 10,000 rpm 4,000 - 10,000 rpm
Speed (110 V, 120 V) 6,000 - 10,500 rpm 6,000 - 10,500 rpm
Sanding stroke 3.0 mm 5.0 mm
Sanding base Ø 150 mm Ø 150 mm
Weight 1.8 kg 1.8 kg
Degree of protection
/ II / II
The specifi ed illustrations can be found at the beginning of the operating instructions.
To Next Page
Loading...
