21
Problem Possible causes Remedy
PLANEX switches
off during work – red
LED on the head of
the machine fl ashes
Dust fi lter on PLANEX clogged Clean the dust fi lter on the PLANEX.
Excessive pressure -> machine acti-
vates overheating protection
Allow the machine to cool and apply less
pressure; in extreme cases, switch on the
external extraction system and set the extrac-
tion control to setting 6.
PLANEX does not
function
Sanding pad blocked – is not run in
after change of pad.
Rotate sanding pad a few times by hand and
run in, also see chapter 7.3
Electrical plug is not connected cor-
rectly.
Check that the electrical plug is inserted
properly.
If other problems other than those listed occur, please contact your Festool service workshop or your
local specialist dealer.
To Next Page
Loading...
