17
LHS 225-E
The long-reach sander is not suitable for wet
sanding.
The user is liable for damage and accidents
caused by improper and non-intended use.
4 Technical data
Long-reach sander LHS 225-E
Power 400 W
No-load speed 400 – 920rpm
Sanding pad diameter 215 mm
Abrasive diameter 225 mm
Tool holder D 13/10
Dust extracter connection 36 mm (27 mm)
Length 1.59 m
Weight (without mains
cable, with sanding pad)
4 kg
Safety class
/ II
5 Machine features
[1-1] Sanding head
[1-2] Plug-it mains cable
[1-3] ON/OFF switch
[1-4] Extractor connector
[1-5] Plug-it connection
[1-6] Suction sleeve stop
[1-7] Speed control
[1-8] Detachable brush segment
[1-9] Insertion tool / sanding pad
[1-10] Gripping surfaces
The specified illustrations appear at the beginning
of the Operating Instructions.
6 Commissioning
WARNING
Unauthorised voltage or frequency!
Risk of accident
XThe mains voltage and the frequency of the
power source must correspond with the
specifications on the machine’s name plate.
XObserve country-specific regulations.
XConnecting and disconnecting the mains cable
- [2].
Before switching on the power tool, make
sure that the bayonet fitting at the mains
cable is closed fully and locked.
XTo connect the suction hose [3], see also
Section 7.5.
Using a special vacuum sleeve, the PLANEX
suction hose guarantees a permanent fixing and
better protection against kinking.
ON/OFF button [4]
ON (I) Push the ON/OFF switch [1-3] down
and forward.
ON/OFF switch is locked.
OFF (0) Push the ON/OFF switch [1-3] down
and unlock it.
ON/OFF switch moves back to the
0position.
7 Settings
CAUTION
Risk of injury, electric shock
XAlways pull the mains plug out of the socket
before performing any type of work on the
machine!
7.1 Electronics
The power tool is equipped with a brushless
EC-TEC motor for a long service life and power
electronics with the following properties:
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The preselected motor speed is kept constant
through electronic control to ensure a uniform
sanding speed up to a certain load.
Overload protection
If the pressure becomes too high while working,
the power of the machine will be automatically
reduced to prevent overheating.
Speed control
You can regulate the speed steplessly within the
speed range using the adjusting wheel [1-7] (see
Technical data). This enables you to optimise
the sanding speed to suit the material you are
working on.
Overheating protection
Overheating protection is triggered when the
pressure is too high or the cool air openings
are dirty. The power tool beeps three times and
switches off. Let the power tool cool down for
approx. 15 minutes before using it again.
To Next Page
Loading...
