19
LHS 225-E
Customer service and repair. Only
through manufacturer or service work-
shops: Please find the nearest address
at: www.festool.com/Service
1
2
3
5
4
Use only original Festool spare parts!
Order No. at: www.festool.com/Service
– Check the plug and the cable regularly and
should either become damaged, in order to
avoid a hazard, have them replaced by an
authorised after-sales service workshop.
To ensure constant air circulation, always keep the
cooling air openings in the motor housing clean
and free of any obstruction.
In the event of a slowdown in performance or
increased vibrations, blow and clean cooling air
openings.
9.1 Cleaning the cool air filter [8]
If the cool air filter is blocked, the motor may
not be sufficiently cooled and the power tool
may switch off after three beeps because the
temperature is too high.
XClean all cool air openings on a regular basis.
XX Remove the filter sieve on the sanding head.
XX Remove any deposits in the sieve.
XX Remove any deposits in the openings in the
housing.
XX Insert the filter sieve until it engages.
Let the power tool cool down for approx. 15minutes
before using it again.
10 Accessories
Use only original Festool sanding pads. Low-
quality sanding and polishing pads may cause
serious machine imbalance that decreases the
quality of the working results and increases wear
on the power tool.
Festool provides comprehensive accessories
which allow you to use your power tool effectively
and for diverse applications, e.g.
• Additional hand grip ZG-LHS 225
• Harness TG-LHS 225
• Mobile dust extractor CTL/M 36 E AC PLANEX
The order numbers of the accessories and tools
can be found in the Festool catalogue or on the
Internet under “www.festool.com”.
11 Environment
Do not dispose of electric power tools
in household waste! Recycle devices,
accessories and packaging! Observe
the valid national regulations.
To Next Page
Loading...
