15
CS 50 EB
- Wear suitable personal protective equipment:
ear protection to reduce the risk of hearing
loss, safety goggles, a dust mask to prevent
inhalation of harmful dust, protective gloves
when working with raw materials and when
changing tools.
- To minimise noise, the tool must be sharpened
and all noise reducing elements (covers etc.)
must be properly adjusted.
- When cutting wood, connect the ma-
chine to a dust extractor corresponding to
EN 60335-2-69, dust category M.
- To minimise the creation of dust, the machine
is to be connected to a suitable dust extractor,
and all the elements for dust collection (ex-
tractor hood etc.) must be properly set.
- Never process material containing asbestos.
- Make sure that there is adequate lighting in
the room or workplace.
- Always assume the correct position before
starting work:
- front at the operating end,
- facing the machine,
- next to the cutting line.
- Use the accompanying workpiece holder to
guide the workpiece accurately past the saw
blade.
- Always use the supplied spacer wedge and
the guard. Ensure that they are set correct-
ly as described in the operating manual. An
incorrectly set spacer wedge and removing
components that are required for safety rea-
sons, such as the guards, can result in serious
injuries.
- Use a suitable device to support long work-
pieces and ensure that they are horizontal.
- Pull the plug from the main power socket be-
fore changing tools and rectifying faults such
as removing trapped splinters.
- Do not remove offcuts or other workpiece
parts from the cutting area while the tool is
still running and until the saw blade stops.
- If the saw blade is blocked, switch the machine
off immediately and disconnect the mains
plug. Do not remove the jammed workpiece
until you have done this.
- Cutting rebates or grooves is only permitted
with a suitable protective device fitted, e.g. a
protective tunnel over the saw table.
- You must re-install the safety equipment im-
mediately after work that requires the guard
to be removed, see sec. 5.2.
- Do not use circular saws for cutting slots
(grooves in workpiece).
- Before transporting the machine, make sure
that the top protective guard covers the top
section of the saw blade.
- Do not use the top protective cover as a handle
for transportation!
- When not in use, store the push stick in the
holder provided on the machine.
4.3 Noise and vibration information
Sound pressure level
Idling / processing 84 / 90 dB(A)
Noise power level
Idling / processing 97 / 103 dB(A)
Measurement tolerance K = 3 dB
Wear ear protection!
Measured acceleration < 2.5 m/s²
The specified emissions values (vibration, noise)
– are used to compare machines.
– They are also used for making preliminary es-
timates regarding vibration and noise loads
during operation.
– They represent the primary applications of the
power tool.
Increase possible for other applications, with oth-
er insertion tools or if not maintained adequately.
Take note of idling and downtimes of machine!
4.4 Residual risks
In spite of compliance with all relevant design
regulations, dangers may still present them-
selves when the machine is operated, e.g.:
- Workpiece parts being thrown off,
- Parts of damaged tools being thrown off,
- Noise emission,
- Sawdust emission.
5 Setting up, commissioning
Ensure that the floor around the machine is level,
in good condition and free of loose objects (e.g.
chips and offcuts).
5.1 Mounting the machine
The machine can be set up with or without the
legs folded out (Fig. 1 and 2) (the “Floor“ model
does not include folding legs).
To Next Page
Loading...
