3
Dimensions & Utility Connections
Installation
Warning: Read this User’s Guide
before installing. Damage caused by improper installation will not be
covered under warranty.
1. Inspect the container for visual or hidden damage. The carrier must be notified of any punctured or
damaged cartons immediately.
2. Install the grinder in selected location making sure surface is level, and that grinder will fit.
Caution: Never
push equipment against cords or wall outlets.
3. Remove cord from inside hopper and plug into the back of the grinder.
4. Before plugging grinder into 120 volt, 15 amp. wall outlet make sure
outlet is not overloaded, a dedicated circuit is preferred.
5. Following the operating procedures below test grinder for proper
operation.
6. If you need further assistance please call our Technical Support
Dept. at 800-338-2699 or e-mail techsupport@fetco.com.
Warning: To prevent
electrical shock, this
unit must be properly
grounded.
To Next Page
Loading...
