Chapter 1: Safety Precautions
1. The input voltage of the appliance is AC220-240V～50Hz. Please confirm your socket voltage before
connecting the power supply.
2. Disconnect the power supply before dismantling, assembling or adjusting any part of the appliance.
3. The appliance comes equipped with a“Y connection”, If the power cord is damaged, please contact our
customer service or have it directly replaced at your nearest authorized service center. Do not attempt to dismantle
and repair it by yourself to avoid injuries or damages.
4. Before operating the appliance, please check if the power cord, the plug, the juice strainer, the spiral pusher
and any other part is damaged. If any of the said part is damaged, do not operate the appliance and contact our
customer service immediately. Do not attempt to dismantle and repair it by yourself to avoid injuries or damages.
5. For repair and servicing, please contact our customer service or have it directly repaired at your nearest
authorized service center. Do not attempt to dismantle and repair it by yourself to avoid injuries or damages.
6. Please ensure that the juicing body, spiral pusher, juicing body cap and all other dismountable parts are
properly installed before connecting the power supply.
7. Do not insert hands or sharp objects into the feed port and avoid touching the spiral pusher when the appliance
is running to prevent injuries and damages; never replace the spiral pusher with any other objects and observe a
safe distance between your eyes and the feed port to avoid accidents.
8. Prepare food ingredients in sizes smaller than the feed port for ease of entry. Do not process any vegetables or
fruits with pits, hard seeds, thick skin or shells until they are completely removed.
9. When feeding a food ingredient into the feed port, do not exert excessive force but just enough to cut the food
ingredient.
10. Discoloration of juice strainer, juicing body cap, spiral pusher and other accessories after juicing of certain
vegetables or fruits is normal, and will neither affect food quality nor harm your health.
11. Equipped with an intelligent protective chip, the appliance will shut down automatically after 20 minutes of
continuous running. In the event, wait for 20-30 minutes until the motor has cooled down before resuming operation
to prolong the service life of the appliance.
12. The appliance has a current limiting design. Hence, the motor would be locked and the current would rise when
hard food ingredients are processed. When the current is higher than 1.3A, the motor would be alerted and pause
for 2 seconds before reversing automatically for 5 seconds and finally shutting down (food causing obstruction in
the appliance would be discharged when the motor reverses). At this point, hit the “ON” button to resume normal
operation of the appliance.
13. In the event of activation of current limiting, locking of motor or failure of auto reverse, hit the “OFF” button to
shut down the appliance, followed by the “REV” button to discharge any obstruction, and finally hit the “ON” button
again to resume normal operation of the appliance. If the motor is still locked, it is recommended that any
obstruction in the spiral pusher should be removed before resuming operation of the appliance. This action serves
to protect the motor.
14. Do not dismantle the dismountable parts of the appliance immediately after use. Make sure both the motor and
spiral pusher have come to a complete stop with the power supply disconnected before dismantling.
15. Do not sterilize any parts in hot water with a temperature higher than 80℃ or in a microwave oven. It would
lead to permanent deformation and damage. All parts coming in direct contact with food ingredients should comply
with food hygiene standards and be cleaned thoroughly before use.
16. Do not immerse the main body or rinse it under running water or any liquid to prevent damages.
17. Do not clean the appliance with steel wool, abrasive cleaning agents or corrosive liquids (such as gasoline or
To Next Page
Loading...