and conveying them to the juice strainer or the squeezer.
Using Squeezing with the spiral pusher, it used for grinding and filtering the
extracted food ingredients to obtain the juice.
It is used for grinding food ingredients by Squeezing with the spiral pusher
(for fruits and vegetables).
It is used for juice collection.
It is used for residue collection.
It is mainly used for placing food ingredients.
It is used for guiding food ingredients from the feed port to the spiral pusher
for higher juice extraction efficiency.
For disassembly of parts 8
Chapter 3: Directions for Use
Before operating the appliance for the first time, clean the parts that come into direct contact with
food ingredients thoroughly (please refer to “Chapter 4: Maintenance”).
Switch operating instructions:
“Rev”: Activates reverse motion to discharge blockage or
when the motor is locked
“O”: Shuts down appliance
“Soft”: For soft ingredients
“Hard”: For hard ingredients
I. Installation Guide
Please install the appliance by following the steps below:
Connect the juicing body to the main body:
1. Align the “triangular aligning mark” “▼”on the main body to
latch the juicing body onto the main body (the 3 clips on the
juicing body will realize alignment).
2. Turn the juicing body in an anticlockwise direction. When a
click is sounded, it suggests that the connection is
completed.
Align the hexagonal shaft of the spiral pusher with the hole on
the main body and push it horizontally until it reaches the
bottom (when alignment fails, turn / adjust the spiral pusher
slightly).
To Next Page