Fit the larger end of the juicer strainer into the tail of the spiral
pusher and push it when the 3 clips of the juicer strainer align
with the 3 clamping slots in the juicing body. (the juice strainer is
used with the juicing button in the rear only. this function is used
for juicing.)
The “triangular alignment mark” on the squeezer should
meet with the arrow on the juicing body followed by an
anticlockwise turn to align with the “unlock triangular mark”
on the juicing body.
Position the juice cup in the corresponding groove on the main
body and align its opening below the juice outlet of the juicing
body.
Position the residue cup below the residue outlet of the juicing
body close to the juice cup.
Connect to the power supply to begin operating the appliance
(make sure the power switch is at the “OFF” position before the
power supply is connected).
Wash vegetables and fruits, cut them into sizes fitting the inlet
of the feed port and place them on the food tray.
Once the “Soft/Hard” button is pressed, operate the
appliance for no longer than 10 minutes per usage.
To Next Page