DCP-10
Page 10/27
5.5 Idle function:
For idle function configure one of the configurable outputs as idle.
Refer to the flow chart 5.7 for start and stop for idle control flows.
5.6 Preheat function:
For Preheat function, configure one of the configurable outputs as Preheat. The controller has 3
selectable preheat control modes as below:
Mode 1 — during preheat time, preheat relay output energizes.
Mode 2 — during preheat time, preheat relay output energizes until the successful ignition.
Mode 3 — during preheat time, preheat relay output energizes until safety-on delay times out.
During crank period, the Preheat relay output will not energize in any of above modes.
Refer to the flow chart 5.7 for start and stop for Preheat control flows.
When the Preheat relay output energizes, LCD displays the icon of preheat operating status:
To Next Page
Loading...
Need help?
General