DCP-10
Page 1/27
1. Description
The DCP-10 is an Automatic Controller for generator. When running in “AUTO” mode, it starts the
Genset after receiving remote start signal and on failure automatically stops the Genset. The
generator’s controlling procedure and protection parameters can be modified, which fully meets the
Genset’s requirements of automatic start, stop control and basic protection.
The module displays fault conditions, operational status and related metering data on panel LCD.
LCD has a backlight function so that the operator can read running parameters clearly even in the
shadow.
The controller has 2 modes: AUTO and MANUAL. Either can be chosen through the panel push
button.
Measures and displays generator’s output voltage, current, oil pressure, coolant temperature,
frequency, DC source voltage, etc.
True RMS measure of voltage and current, which ensures the data more accurate.
Control the close/open of generator output switch.
Equipped with built-in communication interface to configure parameters by PC.
All connections of controller are by secure plug and socket, for ease and convenience to connect,
move, maintain and replace the device.
This manual is only suitable for DCP-10 Automatic control module, user must carefully read
this manual first.
To Next Page
Loading...
Need help?
General