Farmer-Helper DW30 Chipper 21 Revision 09 - 2017
5.6 CONTROLS
All controls are conveniently positioned next to
where the operator would stand when feeding
the machine to provide easy operation. Review
this section to familiarize yourself with the loca-
tion and function of each control before starting.
1 Deflector Position:
Each discharge hood is equipped with a
deflector on the end to place the chips
exactly where desired.
Manual Clamp:
The deflector is held in place by clamp-
ing bolts on each side. Loosen the
clamps, move the deflector and tighten
the clamps. Position as desired.
2. PTO Control:
If you are not familiar with the location of
the PTO control on your tractor, review
your tractor's Operator's Manual.
Always engage the PTO control slowly
when the engine is running at low idle
RPM.
Disengage the PTO control slowly at low
RPM to allow the machine to slow and
stop before engaging the PTO brake.
Remember the PTO drives the rotor.
When the PTO is engaged the rotor will
also start to turn.
To Next Page
Loading...