EVSE Operation And Status Information
Indicator Description
1 — AC Indicator LED
Green indicates READY
RED Indicates a fault
2 — Fault Indicator LED
Green indicates READY
RED indicates a fault
3 — Charge Level Indicator LED's
All ON indicates system ready and not
charging
LED's turning on and of f in sequence
indicates vehicle charging
• When the EVSE is first plugged in it will go through an initialization and self test.
For the first three seconds af ter plugging in your EVSE all the LED's will remain off.
• After approximately three seconds the EVSE performs an internal self test and Ground
Continuity Test. This process takes approximately six seconds.
• During the internal self test the unit turns on one Charge Level Indicator LED every
1.5 seconds until all the Charge Level Indicator LED's are illuminated.
AC LED
Fault Indicator
LED
Charge Level Indicator LED's Time
• • •ooo
1.5 sec
• • ••oo 3.0 sec
• • •••o 4.5 sec
• • •••• 6.0 sec
• If the self test is successful the AC LED, the Fault Indicator LED and the four Charge
Level LED's will turn solid green.
• The EVSE LED's will be used to indicate t he vehicle's connection status if no faults are
found during the self test.
GETTING STARTED
14
To Next Page
