7. Plug the EVSE into the charge receptacle. Push the EVSE in firmly until it is completely
engaged (if not completely engaged the vehicle may not charge).
NOTE:
• The vehicle will initiate the charging
cycle automatically when all the condi-
tions are satisfied.
• The vehicle battery gauge will show
the pattern for charging.
• Do not use an extension cord with
the EVSE.
• To remove t he EVSE push the button
on the connector and pull firmly to
remove it from the vehicle’s charge
receptacle.
8. Close the charge receptacle door.
NOTE:
• In the event of an error in the charging
process the AC power to the vehicle will
stop and a red indicator will illuminate
on the EVSE.
• Keep the door for the charge receptacle
closed when not in use.
GETTING STARTED
17
To Next Page
