IN CASE OF EMERGENCY 249
GEAR SELECTOR OVERRIDE
If a malfunction occurs and the gear selector
cannot be moved out of the PARK position, you
can use the following procedure to temporarily
move the gear selector:
1. Turn the engine OFF.
2. Apply the Electric Park Brake.
3. Locate the bezel and boot assembly.
Gear Selector Bezel Location
4. Carefully separate the gear selector bezel
and boot assembly from the center console.
Removing Gear Selector Bezel
5. Press and maintain firm pressure on the
brake pedal.
6. Insert a small screwdriver or similar tool
down into the gear selector override access
hole (at the right front corner of the gear
selector assembly), and push and hold the
override release lever down.
Gear Selector Override Location
7. Move the gear selector to the NEUTRAL
position.
8. The vehicle may then be started in
NEUTRAL.
9. Reinstall the gear selector bezel.
WARNING!
You or others can be badly burned by hot
engine coolant (antifreeze) or steam from
your radiator. If you see or hear steam coming
from under the hood, do not open the hood
until the radiator has had time to cool. Never
try to open a cooling system pressure cap
when the radiator or coolant bottle is hot.
7
21_FD_OM_EN_USC_t.book Page 249
To Next Page
Loading...
