36 GETTING TO KNOW YOUR VEHICLE
POWER MIRRORS
The power mirror switch is located on the
driver’s door trim panel.
To adjust the mirror, rotate the mirror selection
switch to the left or to the right and then push
the mirror adjustment switch in the four
directions indicated by arrows.
NOTE:
To adjust the power mirrors, the ignition must
be in the ON/RUN position.
Once the mirror is adjusted, rotate the
control to the neutral position to avoid acci-
dental movements.
The power mirror switches will remain active
for up to three minutes after the ignition is
placed in the OFF position. Opening either
front door will cancel this feature.
Power Mirror Switch
FOLDING MIRROR
The exterior mirrors are hinged to allow the
mirror to pivot forward or rearward to help avoid
damage. The mirror has three detent positions:
full forward, normal and full rearward.
Folding Exterior Mirror
POWER FOLDING MIRRORS — IF
E
QUIPPED
If equipped, the outside mirrors can be folded
using the power folding mirror switch, located
on the driver’s door trim panel. The power
mirror switch will operate with the ignition in the
ON/RUN position, and for three minutes after
the ignition is placed in the OFF position. This
feature will disable if either front door is
opened.
WARNING!
Vehicles and other objects seen in an outside
convex mirror will look smaller and farther
away than they really are. Relying too much
on side convex mirrors could cause you to
collide with another vehicle or other object.
Use your inside mirror when judging the size
or distance of a vehicle seen in a side convex
mirror.
1 — Mirror Selector Switch
2 — Mirror Adjustment Switch
21_FD_OM_EN_USC_t.book Page 36
To Next Page
Loading...
