Fiat Ducato - Page 59

Storing vehicle speed
Proceed as follows:
❒ turn ring nut A fig. 66 - fig. 67 to ON
or
(according to the version) and
press the accelerator pedal so that
the vehicle reaches the desired
speed;
❒ move the stalk upwards (+) for at
least one second, then release it. The
vehicle speed is now stored and
you can therefore release the
accelerator pedal.
If necessary (e.g. when overtaking)
acceleration is possible by simply
pressing the accelerator pedal:
releasing the accelerator pedal the car
will return to the speed stored
previously.
Restoring the stored
speed
If the device has been deactivated, for
example by depressing the brake or
clutch pedal, the stored speed can be
restored as follows:
❒ accelerate progressively until a speed
close to that stored is reached;
❒ engage the gear selected at the time
that the speed was stored;
❒ press button B fig. 66 - fig. 67.
Increasing the stored
speed
This can be done in two ways:
❒ by pressing the accelerator and
storing the new speed reached
or
❒ by moving the stalk upwards (+).
Each activation of the lever
corresponds to an increase in speed of
about 1 km/h, whilst keeping the lever
upwards varies the speed continuously.
Reducing the stored
speed
This can be done in two ways:
❒ by switching off the device and then
storing the new speed;
or
❒ by moving the stalk downwards (-)
until the new speed, which will be
stored automatically, is reached.
Each movement of the lever will
correspond to a slight reduction in
speed of about 1 km/h, while keeping
the lever held downwards will decrease
the speed continuously.
Deactivating the device
The device can be switched off by
the driver in the following ways:
❒ turning ring nut A to OFF or O
(according to the version);
❒ by stopping the engine;
Deactivating the
function
The device can be switched off by the
driver in the following ways:
❒ turning ring nut A to OFF or O
(according to the version);
❒ pressing the button B, both with
symbol II and symbol CANC/RES,
the system pauses;
❒ by stopping the engine;
❒ by pressing the brake pedal or
operating the handbrake;
❒ by pressing the clutch pedal;
❒ requesting a gear shift with an
automatic transmission in sequential
mode;
❒ with the vehicle speed below the set
limit
55