5 / 18
Fiberroad may make changes at any time to the products or specifications contained herein without notice
Fiberroad is trademarks of Fiberroad technology Co.,Ltd.©2021 Fiberroad technologu co.,ltd All right reserved
Warning!
Please don’t open the cover
Opening the cover of this equipment is absolutely forbidden.
This has an electric shock hazard. Besides, this is a factor that may cause faults.
Please don’t use when the equipment is abnormal
In case of abnormal conditions like fume, peculiar smell, strange sounds, etc., please stop
using the equipment lest that fire or electric shock occurs. Please switch it off immediately, and
then ask the sale shop or sale site from which you purchased it for repair after the smoke surely
disappears. Never repair it by yourself, lest that hazard occurs.
When using AC power: please pull out the power plug from socket.
When using DC power: please remove the power cable from junction board.
Please don’t damage the power wires
Please don’t scratch, damage or stretch the power wires, otherwise the power wires may
break and cause hazards of fire or electric shock.
Plug in the plug properly
When using AC power, the power plug should be fully inserted. Besides, please don’t use
loose socket to avoid bad contact. Otherwise fire or electric shock may occur.
The power wires should be firmly connected with junction board
When using DC power, the power wires should be firmly connected with junction board. As
long as the [0V], [-48V] and [FG] junctions are contacted, not only the internal power of the
equipment will fail, but also fire or electric shock may occur.
Hold the plug when plugging it in/out
When plugging in or pulling out the power wires, please make sure to hold the plug with
your hand. Stretching the wires parts may damage them and cause electric shock or fire.
Please don’t touch the plug/junction board with wet hand
Please don’t touch the power plug or connect the junctions with wet hand. Otherwise
electric shock may occur.
Plug/junction board cleaning
Please make sure that the plug and junction board are not covered with dust before you connect
them. If they are covered with dust, fire or electric shock may occur.
Please don’t touch the equipment in thunder
To Next Page
Loading...