Trial running
After connecting water to the pool system perform a test run.
Ensure that:
Appliance is horizontal and on a firm base.
Plumbing is firmly connected, using the approved type of pvc primer, glue or couplings.
Electrical wire is firmly connected (all screws tightened correctly at terminals and intermediate
circuit breaker), insulated and GROUNDED correctly.
TURN ON YOUR POOL CIRCULATING PUMP “ON”
TURN ON THE BREAKER FOR THE HEATER
TURN ON YOUR HEATER WITH THE “ON/ OFF” SWITCH
OBSERVE THAT THE HEATER STARTS WITHIN 1 MINUTE BY KEEPING AN EYE ON THE PRESSURE
GAUGE.
ONCE THE HEATER TURNS ON, PRESSURE WILL CLIMB. LEAVE IT RUNNING FOR 5 MINUTES TO ASSURE THAT
ALL PARAMETERS ARE CORRECT
◦
ATTENTION: THE HEAT PUMP ONLY FUNCTIONS WHEN WATER FLOW IS PRESENT.
10
To Next Page
Loading...
