IMPORTANT SAFETY INSTRUCTIONS
1.General
These instructions are for correct installation, and optimum performance of the POOL PUMPS.
These are single-stage centrifugal pumps designed to operate with pool equipment;
• Sand Filters
• Cartridge Filters
• Mod Media Filters
• DE Filters.
• Maximum operating water temperature is 120'F
• Compatible with both CHLORINE or SALT WATER SYSTEMS
2.Installation
• Should be installed horizontally.
• The suction, pipe of the pump should be as short as possible. The rating label must be visible
after installation.
• Must be permanently connected to fixed wiring. Part including electrical components except
remote control devices must be located or fixed so that they cannot into bath.
• Ground and Bonding must BOTH be connected.
3. Pipe Assembly
• The suction and discharge pipes should not put any stress on the pump.
• Included fittings are designed to seal once installed. Please Hand tighten and then turn ¼ turn
by water pump pliers.
4.Electrical connection
• The electrical system must be in accordance with local building and electrical codes.
• A service disconnect is required within reach of the unit.
• Wiring and breaker size, as per local codes.
• The equipotential BONDING between the pool and the pump must be made.
• Wire serving as equipotential bonding conductors shall be a BARE Copper Wire, #8 or thicker.
5.Controls Prior to initial Start-Up
• Verify that the pump shaft turns freely.
• Check that the mains voltage and frequency are according to the name plate. ( 240 VAC at the
2
To Next Page
Loading...