Page 9
* The furnace's Draft Safeguard switch assembly can remain in place as installed at the factory, or
the Draft Safeguard switch assembly can be removed (relief box opening sealed with Block-off
Plate and switch replaced with Splice Connector from Kit KGASW0101/02012SP).
† The Draft Safeguard switch assembly must remain installed and operational in the furnace.
§ See Equivalent Length Table II. Fewer elbows permit longer straight length & vice-versa.
‡ 3"-to-4" increaser is required between vent pipe and power venter.
General Wiring:
For complete installation information refer to the Field Controls SWGII-4CC Power Venter Installation
Manual for details (P/N 46295100.)
To Next Page
Loading...
