EN
CORDLESS GRASS SHEAR & HEDGE TRIMMER USER'S MANUAL
14
Maintenance and storage
8. MAINTENANCE AND STORAGE
Maintenance
ATTENTION:
Disconnect the charger if you will not be using it for a long time, if you are changing the tool
or performing maintenance on the tool.
Check whether the device is showing signs of wear.
If the charger is damaged (cover, conductors or connector), immediately arrange their replacement at an
authorised service centre or from the vendor.
Regular care for the machine will ensure not only a long lifetime and performance
Before use always visually check for worn or damaged parts.
Replace damaged or worn parts. To ensure that the machine always remains balanced, always replace the
entire set of the worn or damaged tools.
Worn or damaged machine parts may only be replaced at an authorised service centre or arranged by the
vendor.
Before cleaning disconnect this product from the power source.
To clean the plastic parts of the product, use a soft cloth dipped in lukewarm water. Do not use aggressive
cleaning products and solvents as this could damage the surface of the appliance.
Do not clean the machine under running water or submerge under water.
After changing the working tool, check that the working tool is secured in its storage position.
After each use of the shear the blade must be cleaned and lubricated. If the shear is used non-stop for
extended periods of time, lubrication should be performed during work.
Storage
Store the tool in a dry location at a sufficient distance from heat sources or dangerous vapours.
Do not place any other items on the machine.
To Next Page
Loading...
