FieldServer ProtoCessor ProtoNode FPC-N38

Need help?

Do you have a question about the FieldServer ProtoCessor ProtoNode FPC-N38 and is the answer not in the manual?

Summary

BACnet;LONWorks Setup

Configure DIP Switches

Setting Node;ID Device Instance (DIP Switch A0-A7)

Explains setting Node-ID/Device Instance and MAC Address using DIP switches A0-A7.

Using S Bank DIP Switches for Configuration Files

Describes using DIP switches S0-S3 to select and load configuration files programmed by the OEM.

Setting Serial Baud Rate (DIP Switch B0-B3)

Details using DIP switches B0-B3 to set the serial baud rate for interfaced systems.

Interfacing ProtoNode to Host OEM Device

Wiring ProtoNode RER to RS-485 Field Protocol

Wiring ProtoNode LER to LonWorks Network

Wiring Connections Pinouts

Powering Up the ProtoNode

Instructions on applying power to the ProtoNode RER or LER, specifying voltage requirements.

Connecting to ProtoNode Web GUI for IP Setup

Connect PC to ProtoNode via Ethernet

Explains how to connect a PC to the ProtoNode using an Ethernet cable and setting the PC's IP address.

Accessing ProtoNode Web GUI

Guides on opening a web browser and entering the ProtoNode's IP address to access its Web GUI.

Network Settings Configuration

Shows the Network Settings screen in the Web GUI for modifying IP address, Netmask, and Gateway.

Setting IP Address for BACnet;IP

Details how to navigate the Web GUI to configure network settings like IP address, Netmask, and Gateway.

Troubleshooting ProtoNode Issues

Check Wiring and Settings

LED Diagnostics for Modbus RTU

Taking Logs with FieldServer Utilities