2.1 Installation guide
Install the stem
The basic installation of the E-scooter has been completed before leaving the factory. After receiving the scooter, you
only need to unfold the stem and assemble the handle bar.
① Take out the stem and riser from the accessories
kit, open the stem clamp, insert the riser to the bottom
of the stem.
③ Take out the spring of the accessory box, put it inside
the side of the stem bottom, the side with the clamp slot,
then align it with the front clamp slot and buckle it. Align
the stem quick release with the slot free side, pass it
through the bottom connection of the stem. After placing
the gasket on the other side, place the stem adjusting nut.
④ Tighten it with the stem adjusting nut to secure the
connection between the stem quick release and the stem.
Close the stem quick release to complete the installation
of the stem.
② Then close the stem clamp.
7
(Caution：Please make sure the stem is tightened and stem quick
release is in closed status, otherwise there are security risks.)
To Next Page
Loading...
