7
2.1 Installation guide
lnstall the handlebar
① Raise the handlebar to the right position. ② Align the handlebar scale to the front of the bike.
③Cover the riser cover, use a three-fork wrench to lock the screws, and adjust the handlebar angle to 5~10°
upward parallel to the ground, and then tighten the screws.
（ATTENTION: The riser cover screws should be tightened with force to avoid safety hazards）
5°-10°
The basic installation of the bike has been completed before leaving the factory. When you receive the bike, you only need
to install the handlebar, meter, headlight, front wheel, pedals, and lock the seat saddle.
To Next Page
Loading...
