1.4 Function DESC
Handlebar
Battery
Front Brake
(The left side is front brake)
(Push up / down to
switch between
dipped beam and high beam)
(Pull the handle outward to shift down)
(Pull the handle outward to shift up)
(The right side is rear brake)
(For emergency charge ONLY)
(In case of overtaking, road section affecting
safety visibility or emergency, slow down and
ring the bell for signal)
Rear Brake
7 Speed Shirft Up
7 Speed Shift Down
(Gently press down the button to switch to
the pure electric mode, the stonger the press,
the faster the speed)
Electric mode button
USB Charging Port
Bell Button
Headlight button
ChargingPort
(Insert the Fiido charger ONLY)
(Display the current derailleur gear)
Speed Gear Display
(Display remaining power)
Battery Status
(Shows the status of the front
and rear light)
Lights
(Display the current power assisted gear.
For details please check Page12:step 3)
Power Assisted Gear Display
(Display the current range by default,
Double-click the Instrument Power button
to switch the total historical mileage display)
Range
(Display the current speed)
① Click to switch the gear and PAS 0, a total of 3 gears
② Double-click to switch KMH/MPH display.
③ Long press for 3 seconds, when the speed display
enters the flashing state, the cruise control function
can be started.
Power Assisted Gear Switch
Instrument Power
① Long press for more than 3 sec：turn on/off the
power assisted mode.
② Click to turn on/off the headlight and taillight
③ Double-click to display the total historical mileage.
Speed
5
To Next Page
Loading...
