8. What power supply adapter is suggested to charge the M17?
1. Supports QC4.0, QC3.0, QC2.0, PD2.0, PD3.0 and other fast charging protocols, if the
adapter does not support the above protocol, it generally will not trigger the fast charge
function. It is recommended to use 5V 1-2A adapters for non-fast charging adapters. After
setting to UAC mode, inserting USB fast charging will not make it enter the fast charging
mode.
2. Supports a 5.5mm diameter DC round head 12VDC charger to power the whole machine.
3. When the DC voltage is too high and exceeds 16V, the system will automatically
disconnect the DC power supply.
4. When the DC and USB3.0 are plugged in at the same time, the system will detect whether
the USB is a Fast charge, it will use USB to charge the battery if the USB is a fast charge.
5. When the M17 is in UAC mode, it will not enter fast charging mode.
Introduction to system settings menu
Here is the system settings menu of the M17
To Next Page
Loading...
