show up saying that Line output is not affected by volume control, and switching
to line output will set the output volume to maximum, potentially causing harm
to headphones and human hearings! Please unplug the headphones and select
the appropriate device for correct connection before switching to line output).
When turning on "Adjustable volume for line output," there is no prompt.
Select 4.4mm output mode:
BAL/BAL LO available, with BAL out as the default.
(The input priority between 3.5mm and 4.4mm headphone ports: The output will
be given priority in the order of insertion.)
SPDIF OUT
This setting needs to be adjusted only when using coaxial output.
*In D2P mode, playing PCM signal will output native PCM signal; playing DSD
signal, the system will convert DSD signal into PCM signal to output;
*In DoP mode, PCM signal and DSD signal will be natively output.
Note: DoP is preferred, and D2P needs to be selected if some devices do not
support DoP.
Gain
There are four gain levels: high, medium, low, and super high gain modes,
corresponding to four levels of output voltage. You can choose different gains
according to your headphones.
To Next Page
Loading...
