Need help?Do you have a question about the Fiio Pro BTA30 and is the answer not in the manual?
General| Bluetooth Version | 5.0 |
|---|---|
| Bluetooth Chip | CSR8675 |
| Supported Codecs | SBC, AAC, aptX, aptX LL, aptX HD, LDAC |
| DAC Chip | AK4490 |
| USB Chip | XMOS XUF208 |
| Outputs | RCA, Optical, Coaxial, Bluetooth |
| USB DAC Sampling Rate | Up to 384kHz/32bit |
| Coaxial Input Sampling Rate | Up to 192kHz/24bit |
| Optical Audio Format | PCM |
| Coaxial Audio Format | PCM |
| Frequency Response | 20Hz-20kHz |
| Signal-to-Noise Ratio | ≥115dB |
| THD+N | <0.0008% |
| Weight | 115g |
| Inputs | Bluetooth, Optical, Coaxial, USB |
| Power Supply | DC 5V/1A |
| Optical Input Sampling Rate | Up to 96kHz |
Details the function of buttons, switches, and the volume knob.
Identifies all input and output ports on the device.
Describes indicator light status for Bluetooth receiving mode and various codecs.
Details indicator light status for Bluetooth transmitting mode and various codecs.
Explains indicator light behavior when the device is in DAC mode.
Instructions for powering the device on, off, and performing a factory reset.
Guidance on forcing a pairing and understanding the reconnecting state.
How to switch input sources and Bluetooth codecs.
Instructions for connecting to two Bluetooth devices simultaneously in RX and TX modes.
How to enable and disable the aptX LL First mode for specific audio transmission.
Details audio output options and priorities when receiving Bluetooth audio.
Explains audio input options and priorities for transmitting audio via Bluetooth.
Describes input source switching and output priorities in DAC mode.
Important advice on charging, environmental conditions, and safe usage.
Information regarding WEEE directive and proper disposal of the product and batteries.
To Next Page
