TWINFLEX
®
pro Repeater Panel Engineering and Commissioning Manual
5
Technical support will not be available if the instruction manual has not been read and understood.
Please have this instruction manual available whenever you call for technical support.
EMC
This equipment when installed is subject to the EMC directive 2004/108/EC. It is also
subject to UK Statutory Instrument 2006 No. 3418.
To maintain EMC compliance, this system must be installed as defined within this manual.
Any deviation from this renders the installer liable for any EMC problems that may occur
either to the equipment or to any other equipment affected by the installation.
The TWINFLEX®pro System
The TWINFLEX
®
pro system is an intelligent ‘2-wire’ system utilising a conventional type cabling format.
The system is classed as ‘Analogue non-addressable’ due to the architecture used within the design. All
field devices including sounders can be connected to the zone via a common 2-core screened cable.
The devices communicate with the control panel using the ‘TWINFLEX
®
’ data protocol.
Repeater Panel, Remote Display Unit (RDU)
The TWINFLEX
®
pro repeater panel is smaller than the TWINFLEX
®
pro control panel.
It does not itself connect to or control detection devices. Instead, it connects to a control panel and
reports events which occur on the control panel.
It can also perform system controls over the network (i.e. Silence Alarms, Reset, Sound Alarms &
Silence Buzzer).
A maximum of 8 repeater panels can be connected to a single control panel.
To Next Page
