1
CAUTION! Read Carefully
HOT MATERIALS & SURFACES Use gloves and eye protection
while operating the EX6 Extruder. The barrel and nozzle are HOT
and melted plastic can stick to the skin and cause serious injury.
HIGH-PRESSURE EXPLOSION Air trapped inside the barrel
becomes highly pressurized during operation and can cause small
explosions out of the nozzle which will throw molten plastic away in
any direction.
TOXIC FUMES Some plastics like PVC can produce dangerously
toxic fumes when they are heated. Always carefully review the
MSDS of any material before using it in the EX6 to avoid dangers to
your health. Always use the EX6 in a well-ventilated area.
In Case of Emergency pull the power cord out of the machine.
Only use the EX6 to extrude thermoplastic polymers. No other use
has been tested or approved by Filabot.
Always STOP the extruder before clearing the feed port or removing
the screw. Never stick anything into the feed port while the screw is
turning as this could damage your system.
The EX6 is designed for indoor use only. Operate in a clean, dry
area.
Check the AC input voltage specified on the S/N Label near the
power inlet. Only use the specified input voltage to operate the EX6
or damage to the components could occur.
Do not use this device if any parts appear missing or damaged.
Do not modify this device without authorization from Filabot.
Contact Filabot with any questions
1-802-505-6772
contact@filabot.com
To Next Page
Loading...