FILLON TECHNOLOGIES Fill-One - Page 36

36
Fill-One by Fillon Technologies
● Do not store anything other than its
accessories in a Fill-One machine.
● Do not unscrew the silencers from a
Fill-One machine.
CAUTION
● Do not use a Fill-One machine without
fixing it to a work surface using the screw
provided.
● Do not connect the Fill-One machine to
an air network at less than 7 bars (100
psi).
● Do not exceed the paint level indicated
on the cup support.
● Do not connect the Fill-One machine to
an air network which does not have an air
filter fitted.
● Do not force cup support insertion in a
Fill-One machine.
● Do not force the “aerosol /cup support/
cap” assembly insertion in a Fill-One
machine.
● Do not put your fingers around the area
where the Fill-One machine door closes.
● Do not stand on a Fill-One machine.
● Do not sit on a Fill-One machine.
● Do not use anything other than the
handle to activate the door of a Fill-One
machine.
● Do not use a Fill-One machine without
the adjustable platform.
● Do not put animals in a Fill-One
machine.
MAINTENANCE INSTRUCTIONS
BEFORE ALL MAINTENANCE
OPERATIONS, DISCONNECT THE
MACHINE’S AIR SUPPLY AND
CONSULT THE INSTRUCTIONS.
● In order to sustain optimum product
level, regular maintenance is required:
clean using a cloth soaked in soapy
water.
● In order to stop electrostatic charges
accumulating, only clean the plastic parts
with a cloth soaked in soapy water or
solvent or thinner recommended by the
paint manufacturer.
● Also clean any paint splatters on or in
the machine.
● Eliminate paint stains using solvent
or thinner recommended by the paint
manufacturer.
● If you experience trouble, please
refer to the following “Troubleshooting
Table”.