Need help?Do you have a question about the FilterSense DynaCHARGE PM 1 Series and is the answer not in the manual?
FilterSense technical support contact information and required details for assistance.
Legal disclaimer regarding manual usage, distribution, and copyright notice.
Explains warning symbols and conventions used in the manual for user understanding and safety.
Critical safety guidelines including area classification, environment, grounding, and personnel.
Lists other relevant FilterSense documentation for comprehensive product understanding.
Provides an overview of the DynaCHARGE PM 1, its capabilities, and common applications.
Details and illustrates the main hardware components that constitute the PM 1 unit.
Presents detailed technical specifications for the PM 1 electronics module.
Lists technical specifications for the sensor probe, including mounting and materials.
Explains how to configure the DynaCHARGE PM 1 model using order codes.
Guides on selecting an appropriate installation location based on temperature, pressure, and area.
Provides guidelines for straight run considerations for optimal sensor performance.
Specific installation considerations for powder flow and horizontal duct applications.
Describes available process mount types: Threaded and Quick-Clamp for secure fitting.
Details mounting considerations, including probe protrusion and welding best practices.
Warns against improper extensions and unsuitable mounting materials to ensure proper function.
Explains the installation and purpose of a sensor test port for response testing.
Details the available conduit entries and proper routing for moisture prevention.
Explains grounding requirements for reliable operation and safety, including hazardous areas.
Illustrates terminal connections for power and alarm relays on the PM 1-A.
Shows terminal connections for the loop-powered analog output on the PM 1-T.
Describes the user interface components: keypad, digital readout, and status LEDs.
Explains how to navigate live readings, access settings, and perform user login.
Details the configuration settings menu structure for the PM 1-A model.
Details the configuration settings menu structure for the PM 1-T model.
Explains signal smoothing adjustment for fine-tuning real-time output and its impact.
Details alarm settings, logic, and fail-safe relay states for the PM 1-A.
Describes analog output features, range selection, and forcing for the PM 1-T.
Guidance on setting alarms for detecting leaks in filter media based on readings.
Guidance on setting alarms for detecting relative changes in mass concentration.
Guidance on setting alarms for powder flow and loss of flow conditions.
Procedure for checking the general functionality of the monitor upon initial power up.
Describes the in-situ test for confirming proper installation and zeroing.
Procedure for verifying the sensor's response to an actual increase in particulate.
Information on returning the device for factory testing and NIST traceable calibration.
Steps to resolve display errors ERR 1 and ERR 2 by checking relevant components.
Troubleshooting for zero, elevated, low, or dynamic particulate readings.
Troubleshooting steps for issues with relay and analog output functionality.
States that electronics modules are drift-free and require no user calibration.
Recommends an annual inspection for particulate sensors after initial checks.
Outlines specific steps for inspecting the sensor enclosure, probe, and mount.
Provides step-by-step instructions for easily replacing the PM 1 electronics module.
General| Brand | FilterSense |
|---|---|
| Model | DynaCHARGE PM 1 Series |
| Category | Accessories |
| Language | English |
To Next Page
