THE SPRAY GUN PEOPLE
FOR PRODUCT INFORMATION CALL:
1-800-742-7731
SHARPE: P.O. Box 1441 Minneapolis, MN 55440-1441
1-800-742-7731, www.sharpe1.com
310746 4/2004, Rev. F 5/2007
Gravity Feed and HVLP Air Spray Guns
*Maximum HVLP Compliant Pressure
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
Model
Part
No.
Needle/
Nozzle
Size
Maximum
Working Air
Pressure
Recommended
Maximum Inbound
Air Pressure
FX100
Mini-HVLP
248752 1.0
100 psi
(0.7 MPa, 7 bar)
29 psi
(0.20 MPa, 2.0 bar)*
FX200
Conventional
248753 1.4
100 psi
(0.7 MPa, 7 bar)
60 psi
(0.41 MPa, 4.1 bar)248754
1.8
FX300
HVLP
248755 1.3
100 psi
(0.7 MPa, 7 bar)
29 psi
(0.20 MPa, 2.0 bar)*
248756 1.4
248757 1.5
248758 1.8
FIG. 1
21
30
6
A
Setup
1. Install an air pressure regulator on gun air supply line to
control air pressure.
2. Install a shutoff valve downstream of the air regulator to shut
off gun air.
3. Connect a clean, dry, filtered air supply.
4. Connect air supply line to gun air inlet (21). FIG. 1. Connect
other end to shutoff valve.
5. Install fluid filter (29) into fluid inlet (6). Refer to page 6.
6. Screw on gravity cup (30).
7. Remove gravity cup cover (A) and fill cup with solvent to flush
if this is first time using equipment.
Flush Spray Gun
Flush spray gun before using it. Use solvent that is compatible
with gun wetted parts and fluid that will be sprayed. Use lowest
possible pressure, and spray into grounded metal waste
container.
After flushing, follow Pressure Relief Procedure.
Pressure Relief Procedure
1. Turn off gun air supply.
2. Trigger gun into grounded metal waste container.
WARNING
Read warnings, page 2.
WARNING
Follow Pressure Relief Procedure when you stop spraying
and before cleaning, checking, or servicing equipment. Read
warnings, page 2.
II 2 G
To Next Page
General