R2 & R2c
1
2 3
4
5 6
7
8
0
9
ESC
OK
MENU
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
R2
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
GND
+12V
BEEP
GLED
RLED
INWD0
INWD1
GND
+12V
RJ45-1
RJ45-2
RJ45-3
RJ45-6
WD0
WD1
GND
RXD
TXD
GND
485+
485-
RX+
RX-
485B
485A
RX+
RX-
485B
485A
485B
485A
TCP/IP
RS232
RS485
Installation Guide
Step 1
Determine the Location and Positioning
of the Installation
• Avoid installing the terminals in locations that has contact with
a strong light source (e.g direct sunlight, spotlight, fluorescent
light, etc)
• Avoid installing the terminals in locations prone to high moisture
or condensation levels in the air
• The recommended installation height of the terminal from the
ground is 1.2 meter.
Step 2
Mounting Terminals
•
After measuring the height accordingly and make relevant mark-
ing on the wall, drill the screws into the wall to secure the back
plate.
• Attach the terminal to the back plate and tighten the screws. Re-
fer to Appendix II for dimensions and measurements of installa-
tion.
Step 3
Wiring for Power Supply
The power input ports for these models are located at the rear of
the terminals. There is no adapter plug supplied with the models,
instead you need to source for power cable (red and black cables) to
connect the power from the terminal to the AdapTec.
© 2015 Timetec Computing Sdn Bhd. All rights reserved.• 022015
4 feet / 1.2 meter
(recommended)
Fingerprint Door Access &
Time Attendance System
Port USB
Door Lock connector.
Refer to Appendix I
DC12V3A
Power
Supply
3rd party
controller with
26-bits wiegand
output
Wiegand
IN
Power
OUT
Wiegand
OUT
TCP/IP
3rd party controller
with 26-bits wiegand
input
RS232
cable
1. RS485 Single Connection
2. RS485 Network Connection
RS232/RS485
Data Converter
RS232/RS485
Data Converter
To Next Page
Need help?
General
